[. . . ] OWNER'S MANUAL
MAGIC MOTION REMOTE
Please read this manual carefully before operating your set and retain it for future reference.
AN-MR200
Remote control (AKB732955) RF Dongle (EAT614134)
www. lg. com
2
ACCESSORIES
ENERGY AV MODE INPUT
TV
SAVING
1 4 7
LIST
2 5 8 0
MARK
3 6 9
FLASHBK
VOL
ENTER
3D MUTE
FAV
CH
P A G E
MENU INFO
Q. MENU
VOL
ENTER
CH
BACK
MUTE
EXIT
L/R SELECT FREEZE
RATIO
Magic Motion Remote Control Owner's manual and Batteries (AA)
RF Dongle
RF Dongle Cable
Strap
Velcro
REMOTE DESCRIPTION
Pointer (RF transmitter) Blinks the light when operating.
POWER
Turns the TV on or off.
Home
Home
Accesses the Home menu.
Home
ENTER/OK Selects menus or options and confirms your input. [. . . ] *To avoid wireless interference, keep the distance between the RF Dongle and the Wi-Fi dongle at 20 cm.
1 Locate the designated Velcro attachment location on the TV. (The attachment location is different depending on the TV model you own) Velcro
20cm
or
RF SPECIFICATION
The Magic Motion Remote Control communicates with RF Dongle using a 2. 4 GHz bandwidth radio frequency (RF).
*Attach the RF Dongle aligning with the upper left corner bracket.
2 Connect the RF Dongle Cable plug on the RF Dongle to a USB1 jack on the TV.
Output: 1 dBm or lower Maximum Communication Distance: 10 m (32. 8 ft) in an open space Bandwidth: 2. 4 GHz (2. 4035 GHz - 2. 4783 GHz) Transfer Rate: 250 kbps
4
REGISTERING
The Magic Motion Remote Control operates by pairing with your TV. How to register the Magic Motion Remote Control To register the remote control, press the ENTER (or OK) button on the remote control while aiming it at your TV. How to Re-register the Magic Motion Remote Control after Registration Failure Reset the remote control by pressing and holding both the ENTER (or OK) and MUTE buttons for 5 seconds. (Once the reset is complete, the light on the Pointer blinks. ) Then repeat the above procedure to register the remote control.
PRECAUTIONS TO TAKE
ENTER
OK
ENTER
OK
MUTE
HOW TO USE
ENTER
OK
Press ENTER (or OK) button if there is no pointer on your TV screen. If the pointer has not been used for a certain period of time, it will disappear. You can move the pointer by aiming the front of the remote control at your TV then move it left, right, up or down. If the pointer does not work properly after clicking the ENTER (or OK) button, wait for 10 seconds then use it again.
Use the remote control within the maximum communication distance (10 m, 32. 8 ft). [. . . ] If the AP is installed closer than 1 m, the magic motion remote control may not perform as expected due to frequency interference. [. . . ]